Bently Nevada 330101-00-58-10-02-00 3300 XL 8 mm Probe

Technical Specifications Breakdown

Key parameters for the 330101-00-58-10-02-00 are listed below for quick reference:

Industry Applications

Turbomachinery Monitoring

The 2 mm linear range and 7.87 V/mm sensitivity allow early detection of imbalance, misalignment, or bearing wear.

Pump and Motor Protection

In critical pumps and large electric motors, the 330101-00-58-10-02-00 provides reliable displacement data to trigger alarms before mechanical damage occurs. The stainless steel case and PPS tip withstand harsh operating conditions.

Predictive Maintenance Programs

Integrating this probe into a condition monitoring system enables trend analysis and reduces unplanned downtime. The robust TipLoc and CableLoc designs ensure long-term stability in field installations.

Installation and Setup Guidance

Mount the probe using the 3/8-24 UNF thread into a suitable mounting fixture, ensuring the target surface is clean and within the recommended gap setting of -9 Vdc (approximately 1.27 mm). Use three-conductor shielded triad cable for field wiring (0.2 to 1.5 mm² or 16 to 24 AWG). Maximum field wiring length between the 3300 XL Proximitor Sensor and the monitor is 305 meters (1,000 feet). Refer to frequency response graphs for signal rolloff at high frequencies when using longer wiring.

Maintenance and Reliability

Inspect probe cables and connectors periodically for signs of wear or damage. The Viton® O-ring provides a pressure seal; avoid exposing the probe to temperatures below -34°C (-30°F) to prevent premature seal failure. The probe is designed to seal differential pressure between the tip and case, but it is not pressure tested prior to shipment. Contact the custom design department if pressure seal testing is required.

Robust Vibration Sensing for Critical Machinery

In high-speed rotating equipment, undetected shaft vibration can lead to catastrophic failures, unplanned downtime, and costly repairs. The Bently Nevada 330101-00-58-10-02-00 3300 XL 8 mm Probe addresses this challenge with proven eddy-current technology, delivering precise displacement measurements for predictive maintenance. This probe is engineered for demanding environments where accuracy and durability are non-negotiable.

Compatibility and Integration

The 330101-00-58-10-02-00 is part of the 3300 XL family and is compatible with Bently Nevada 3300 XL Proximitor Sensors and monitoring systems. The miniature coaxial ClickLoc connector ensures secure, quick connections. Use only standard extension cables specified for the 3300 XL series to maintain system accuracy.

Selection Guide and Purchasing Advice

When selecting a probe, confirm the thread size (3/8-24 UNF), total length (1.0 meter), and connector type (ClickLoc). The 330101-00-58-10-02-00 is suitable for applications without armor requirements. Please verify current lifecycle status and availability with AutoDCSTech before ordering. AutoDCSTech offers genuine Bently Nevada parts with expert support to ensure you get the right component for your machinery.

Troubleshooting and Common Issues

If output voltage is unstable, verify the gap setting is within the linear range (0.25 to 2.3 mm). Check cable connections for damage or corrosion. Ensure the target material is conductive and within specified temperature limits. For persistent issues, inspect the probe tip for contamination or physical damage.