Bently Nevada 330103-00-06-05-02-CN 3300 XL 8 mm Proximity Probe

Technical Specifications Breakdown

Key parameters for the 330103-00-06-05-02-CN are listed below for quick reference:

Industry Applications

Its 2 mm linear range and robust stainless steel case suit high-temperature environments up to +177°C. The miniature coaxial ClickLoc connector simplifies field installation and replacement, reducing maintenance time. Compared to eddy-current probes with shorter ranges or lower temperature ratings, the 3300 XL series provides extended measurement capability and durability.

Installation & Setup Guidance

Mount the probe using the M10x1 thread with a maximum thread engagement of 15 mm. Ensure the target surface is clean and conductive. For field wiring, use 0.2 to 1.5 mm² (16 to 24 AWG) three-conductor shielded triad cable. The maximum field wiring length between the 3300 XL Proximitor Sensor and the monitor is 305 meters (1,000 feet). Set the initial gap to approximately -9 Vdc for radial vibration applications, corresponding to about 1.27 mm (50 mils) from the target.

Maintenance & Reliability

Inspect the probe cable and connector periodically for damage or corrosion. Avoid exposing the probe to temperatures below -34°C (-30°F) to prevent premature pressure seal failure. The probe sealing material uses a Viton® O-ring; while probes are not pressure tested before shipment, contact the custom design department if a pressure seal test is required. The probe tip material (PPS) offers good chemical resistance in many industrial environments.

Accurate Vibration Monitoring with the Bently Nevada 330103-00-06-05-02-CN

Industrial rotating machinery demands precise, reliable vibration measurement to prevent unplanned downtime and catastrophic failures. The Bently Nevada 330103-00-06-05-02-CN, part of the 3300 XL series, is an 8 mm proximity probe engineered for continuous, non-contact shaft displacement and vibration monitoring in harsh environments. This component offers a proven solution for critical asset protection.

Compatibility & Integration

This probe is designed for use with Bently Nevada 3300 XL Proximitor Sensors and compatible monitoring systems. When installed with intrinsically safe zener barriers per drawing 141092 or with galvanic isolators, it is approved for Class I, Zone 0: AEx/Ex ia IIC T5...T1 Ga; Class 1, Groups A, B, C, D; Class II, Groups E, F, G; Class III. For non-incendive installations per drawing 140979, it is approved for Class I, Zone 2: AEx/Ex nA IIC T5…T1 Gc; Class 1, Division 2, Groups A, B, C, D; and Class I, Zone 2: AEx/Ex ec IIC T5…T1 Gc.

Selection Guide & Purchasing Advice

When selecting a replacement or new probe, verify the required unthreaded length, overall case length, and total length to match your installation. The 330103-00-06-05-02-CN offers a 0 mm unthreaded length, 60 mm case length, and 0.5 meter total length with a ClickLoc connector. AutoDCSTech stocks this genuine Bently Nevada probe and can assist with lifecycle status and availability. Please verify current lifecycle status and availability with AutoDCSTech before ordering.