Bently Nevada 330102-00-13-10-02-00 3300 XL 8 mm Proximity Probe

Technical Specifications Breakdown

Key parameters for the 330102-00-13-10-02-00 are listed below for quick reference:

Industry Applications and Cost Benefits

In a steam turbine application, the 2 mm linear range and -9 Vdc recommended gap setting provide early warning of shaft misalignment, preventing catastrophic bearing failure. The PPS tip and stainless steel case ensure durability in harsh environments, reducing replacement frequency and total cost of ownership. For compressor trains, the probe's 1.0 m cable length simplifies installation near the measurement point, minimizing signal degradation and the need for additional cabling.

Installation and Setup Guidance

Mount the probe using the 3/8-24 UNF thread with a maximum engagement of 0.563 in. Use field wiring of 0.2 to 1.5 mm² (16 to 24 AWG) with a three-conductor shielded triad cable. The maximum distance between the 3300 XL Proximitor Sensor and the monitor is 305 meters (1,000 feet). Set the initial gap to -9 Vdc for radial vibration measurements. Ensure the probe tip is clean and the target surface is smooth for accurate readings.

Maintenance and Reliability

Inspect the probe and cable periodically for physical damage or wear. The probe operates reliably in temperatures from -52°C to +177°C and humidity up to 93% with less than 3% change in Average Scale Factor. Avoid exposing the probe to temperatures below -34°C (-30°F) to prevent premature pressure seal failure. For extended temperature applications, the probe tip can withstand up to +218°C (+425°F) and the cable up to +260°C (+500°F).

Precision Vibration Monitoring for Critical Machinery

The Bently Nevada 330102-00-13-10-02-00 is a 3300 XL 8 mm Proximity Probe designed for reliable, non-contact displacement measurement. This probe is essential for protecting rotating machinery such as turbines, compressors, and pumps from costly failures. By detecting shaft vibration and position changes early, it helps avoid unplanned downtime and expensive repairs.

Compatibility and Integration

The 330102-00-13-10-02-00 is designed for use with Bently Nevada 3300 XL Proximitor Sensors and monitoring systems. When installed with intrinsically safe zener barriers or galvanic isolators, it meets Class I, Zone 0 requirements. For non-incendive circuits, it is suitable for Class I, Zone 2 environments. Always verify system compatibility before installation.

Selection Guide and Purchasing Advice

Choose the 330102-00-13-10-02-00 for applications requiring a 1.0 m cable and miniature coaxial ClickLoc connector. This probe offers a balance of performance and cost efficiency for standard industrial environments. To ensure long-term reliability, consider the operating temperature range and agency approval requirements. AutoDCSTech stocks this model and can assist with lifecycle status and availability. Please verify current lifecycle status and availability with AutoDCSTech before ordering.